Tom Bender
01-22-2021, 8:59 AM
Making these recessed half blind dovetails my marking gauge didn't work out. Is recessed half blind the right term?
450068
Anyway I made this one with a shorter rise so it would bear against the end of the pins. Made the blade from an old utility knife blade. Sharpen first, cut off by grinding a line both sides then snap off.
450069
But it is a little crude so here's the improved version. Steel lockdown bearing and alignment grooves in the bar.
450070
450071
450068
Anyway I made this one with a shorter rise so it would bear against the end of the pins. Made the blade from an old utility knife blade. Sharpen first, cut off by grinding a line both sides then snap off.
450069
But it is a little crude so here's the improved version. Steel lockdown bearing and alignment grooves in the bar.
450070
450071