Hammer K-3 dado set question

[scott vroom]

I'm ordering a 6" dado set for my K-3 Winner. I'm assuming that all of the components (outside blades and interior cutters) will require pin hole boring to align with the 2 pins on either side of the 30mm arbor. Is this correct?

[Tom Bain]

Scott -- I have a 6" Forrest Stack (30mm arbor with Pin holes) that I'm looking to sell - very good condition. PM me if you are interested.

[Erik Loza]

Scott, that's all correct but I want to mention that in case you were getting at having an existing set bored for the pinholes, that's a probably not a good idea. Would need to be originally machined for 30mm + the two pin holes. In case that's what you were getting at. I would jump on Tom Bain's offer.

Erik