David Fried
01-03-2006, 11:02 PM
I have never used or owned a scroll saw but I brought one home from the dump. It looked so bad I almost left it there. Almost. This what it looked like after a little cleaning. Since then I have gotten most of the rust off the table.
28867
First thing I did was plug it in and it works! The tag on the front says it was made by Duro Metal Products.
28868
The OWWM web site states "Duro's lathe was sold by Montgomery Wards" so the tag on the motor wasn't a surprise.
28869
It even came with a foot switch!
28870
Someone was also tossing a beat contractors saw so I tossed it and brought home the stand. I plan on bolting some plywood to the top and putting the scroll saw on it.
28871
I figure it's something new to explore. Thanks for looking.
Dave Fried
28867
First thing I did was plug it in and it works! The tag on the front says it was made by Duro Metal Products.
28868
The OWWM web site states "Duro's lathe was sold by Montgomery Wards" so the tag on the motor wasn't a surprise.
28869
It even came with a foot switch!
28870
Someone was also tossing a beat contractors saw so I tossed it and brought home the stand. I plan on bolting some plywood to the top and putting the scroll saw on it.
28871
I figure it's something new to explore. Thanks for looking.
Dave Fried