View Full Version : Powdercoating
Jeff Chumbley
01-03-2006, 10:39 PM
I read an article in a trade mag recently about lasering into powder coated material. Has anyone done this? I have a 24TT 45w and would appreciate any settings to start from if you have.
Thanks
Jeff
Dave Fifield
01-04-2006, 12:48 AM
There was a previous thread on this topic here http://www.sawmillcreek.org/showthread.php?t=23430&highlight=powder+coat+paint
The best thing for you to do is try it and see how you get on.
Cheers,
Dave Fifield
Bruce Volden
01-04-2006, 7:19 AM
Jeff
I helped a neighbor start up a powdercoating business years ago! Great stuff!! I have burnt through quite a few of his coatings (there are many types of powder paint makeups) and they have varying results. I have found I need increased speed and increased power to do a good jod in one pass. Too slow and the stuff puddles/ melts? Too fast and you can't get through it. This is one tough coating and if one were to get a large contract I'm sure it would work out well. Hope this helps.
Bruce
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.