Matthew Ramsey
12-17-2020, 4:19 PM
Hello all,
I finally pulled the trigger on a slider, and it lands in the shop tomorrow morning (Commissioned by First Choice Industrial in Auburn Ga - great folks!). I opted for the SCM Nova SI 400 over the Minimax as I wanted the extra power while ripping hardwoods, and have 3phase in my shop (American Rotary 25 HP panel). After ordering, however, I noticed that there are very few slider accessories and/or support options that will fit the SCM...
I'm currently in search of:
- A support for the slide (similar to the one used on Minimax machines to mount a parallel fence positioner)
- A crosscut fence with miter control (SCM one was priced at $1800+, about triple the cost of the Minimax one from my understanding)
- Parallel fence (and/or the support mentioned above) - I've talked with Brian Lamb about fitting his on an SCM, but won't know if it fits till the saw lands.
What are others using for Support/Aux fences/parallel fences on their SCM saws?
Thanks!
Matt Ramsey
I finally pulled the trigger on a slider, and it lands in the shop tomorrow morning (Commissioned by First Choice Industrial in Auburn Ga - great folks!). I opted for the SCM Nova SI 400 over the Minimax as I wanted the extra power while ripping hardwoods, and have 3phase in my shop (American Rotary 25 HP panel). After ordering, however, I noticed that there are very few slider accessories and/or support options that will fit the SCM...
I'm currently in search of:
- A support for the slide (similar to the one used on Minimax machines to mount a parallel fence positioner)
- A crosscut fence with miter control (SCM one was priced at $1800+, about triple the cost of the Minimax one from my understanding)
- Parallel fence (and/or the support mentioned above) - I've talked with Brian Lamb about fitting his on an SCM, but won't know if it fits till the saw lands.
What are others using for Support/Aux fences/parallel fences on their SCM saws?
Thanks!
Matt Ramsey