Bryan Cleveland
12-15-2020, 6:57 PM
I own an 18BX that I’ve had 6 months or so. I just noticed that my table insert was actually installed upside down from the factory. I mean I’ve noticed but until yesterday never made a cut with the table tilted(I was at 45 degrees).
I was unable to put the table insert in the table. Hitting the blade I had an 1/8” or better before seating the insert. I tried installing it upside down chamfered cutout for the blade facing up and the insert popped right in plenty of room on both sides of the blade. Unfortunately the hole to secure the insert was not and cannot be countersunk. Insert is not thick enough.
To be clear the chamfered cutout on my insert is on the opposite side from the countersunk hole for the screw to secure the insert.
Anyone else notice this? I’ve contacted Laguna and they responded quickly but I just sent pics to them and they are now closed. I’ll report back what they say.
I was unable to put the table insert in the table. Hitting the blade I had an 1/8” or better before seating the insert. I tried installing it upside down chamfered cutout for the blade facing up and the insert popped right in plenty of room on both sides of the blade. Unfortunately the hole to secure the insert was not and cannot be countersunk. Insert is not thick enough.
To be clear the chamfered cutout on my insert is on the opposite side from the countersunk hole for the screw to secure the insert.
Anyone else notice this? I’ve contacted Laguna and they responded quickly but I just sent pics to them and they are now closed. I’ll report back what they say.