Brian Runau
12-07-2020, 10:17 AM
Good morning. trying to figure out how to locate my layout lines or where to put them for the motises I need to put in this leg for the stringer across the front of a dresser. I need to cut 5 mortises from top to bottom of this leg. I have attached two of their attachments that let me register off the left side of this leg and the one that will keep the domino square to the leg. My problem is I can't figure out how to add a layout line (I can see or a stop) I can register off of so I can cut the mortise in the proper location 90 degrees to the cutting action of the bit. I can't see anything to register off of and not sure what any dimension is from the top or bottom to the center line of the bit. Am I making sense?
Thanks.
Brian
446433
Thanks.
Brian
446433