View Full Version : Does anyone have a RDC6344G Ruida Controller?
Gene Uselman
11-04-2020, 1:36 PM
I have a new machine with one and I cannot get the air assist [wind connection] to function. I tried a different [RDC6442] controller and it works. Thanks Gene
Bill George
11-05-2020, 9:03 AM
I have a new machine with one and I cannot get the air assist [wind connection] to function. I tried a different [RDC6442] controller and it works. Thanks Gene
If its New then go ask the Seller what to do. Never had a Chinese machine with air assist turned on by the controller.
Rob Damon
11-05-2020, 1:45 PM
If this is what the controller looks like:
444518
According to the manual it is the Connector CN-2 , pin 5 for Wind for that controller.
444519
But it needs an electric/pneumatic air valve if one was not provided with the laser similar to this Ruida controller:
444517
Gene Uselman
11-07-2020, 1:49 PM
Thanks guys- I have the Ultimate Air assist set up with more mods of my own- I have found several places to enable the 'wind' terminal and have ticked all of them, still no [negative] signal on the terminal... just wondering if there is something I missed. The system works a treat if I provide the negative signal. Gene
John Lifer
11-08-2020, 3:22 PM
I've an S and it will switch a relay when wired with those two wires +24v and wind. It will work just fine. G model should work the same way. it doesn't send a negative signal, it sends 24V to a relay. Turns on or off at the power settings Air on or off.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.