bob pfohler
10-27-2020, 5:50 PM
A friend has an older jet JWTS 10jf table saw. When it’s colder than 70 degrees the darn motor won’t turn.
If he uses a block of wood and turns the blade really fast it will start running but it has to run 10 minutes before he can put any type of load on the motor.
He had it tested at a motor shop and they said it’s fine. Obviously it’s not, any ideas?
If he uses a block of wood and turns the blade really fast it will start running but it has to run 10 minutes before he can put any type of load on the motor.
He had it tested at a motor shop and they said it’s fine. Obviously it’s not, any ideas?