Is your Incra TS fence hard to move?

[Bruce King]

I saw a YouTuber having a hard time moving his Incra fence and assume many others are just living with it because it’s always been that way. I did for awhile.
Also there is no need to shim the fence to get 90 degrees off the table if you have the fence arm level and the base level.
These two plastic grub screws near the clamp are of little need and they can be too tight or mangled which causes the fence arm to be difficult to move. Plastic screws are at the right side of the picture as the picture is sideways.

[Jay Kepley]

I had an Incra fence on a Jet contractor table saw I sold. When the Incra fence is set up properly, it almost floats. It's an amazing tool. It took me much more time to get it set up properly than it should have, but I attribute that to my own issues, not the tool.

[Brian Holcombe]

I have had one on my router table for 15 years or so, 4-5 of those has been daily use, still moves nicely.