Joseph Mazey
10-18-2020, 8:17 PM
Was wondering if anyone has owned a eBay blue/gray laser and moved to the higher end ones and would have any recommendations/gotchas. I got the eBay one about 18 months ago as more of playing around with cutting ornaments and other things. Over the past year that has turned into zero cutting and a lot of engraving and I am at a point where I would like to move up to a better laser. I really want something quicker, better engraving and to do away with the water cooling. I would like to go no higher than 20K on a new one. A few additional questions and any feedback is appreciated.
1. Software - I use Lightburn with the eBay laser and know that is not going to work with the higher end ones but I do know Corel well enough. Aside from Corel, is there other software that is better?
2. Heatburn/Residue - I use a high tack tape on what I engrave and end up with less residue but still have the cases where I get it and either can wipe it off depending on material, scrub with a gritty soap or sand it off. I assume this to be the case with any laser but did not know if I would see less of it. The one thing I hate with the tape is on little letters the air seems to blow the little tape pieces all over the place inside the machine which is fun to clean up.
3. Cutting - I use a lot of 1/4" MDF. My current laser cannot cut it unless I run real slow, high power and multiple passes and still does not always work. Would say the Mini 24 - 30 watt be able to cut that or what may be a recommended wattage? This is not a high priority, especially if that means jumping into a much pricier laser.
I have a Epilog dealer about 90 minutes from me I have been trying to get down to and at least see what the machines can do. Trotec is about 3 hours so not sure I will be able to see that one in person.
1. Software - I use Lightburn with the eBay laser and know that is not going to work with the higher end ones but I do know Corel well enough. Aside from Corel, is there other software that is better?
2. Heatburn/Residue - I use a high tack tape on what I engrave and end up with less residue but still have the cases where I get it and either can wipe it off depending on material, scrub with a gritty soap or sand it off. I assume this to be the case with any laser but did not know if I would see less of it. The one thing I hate with the tape is on little letters the air seems to blow the little tape pieces all over the place inside the machine which is fun to clean up.
3. Cutting - I use a lot of 1/4" MDF. My current laser cannot cut it unless I run real slow, high power and multiple passes and still does not always work. Would say the Mini 24 - 30 watt be able to cut that or what may be a recommended wattage? This is not a high priority, especially if that means jumping into a much pricier laser.
I have a Epilog dealer about 90 minutes from me I have been trying to get down to and at least see what the machines can do. Trotec is about 3 hours so not sure I will be able to see that one in person.