Soren Christensen
10-02-2020, 3:55 PM
Hi guys,
So Im expecting my first laser (really to get my feet wet and see how everything goes).
Its a chinese laser 60w, 600x400mm, not a k40.
But the thing im wondering about, is how do I figure out the best settings, in the shortest amount of time?
I know I can do trial and error, but there has to be a better and easier way, than to waste alot of materials?
Is there like a template, where you can set the various power/speed, cutting and engraving?
Any assistance will be helpful and much appreciated :)
So Im expecting my first laser (really to get my feet wet and see how everything goes).
Its a chinese laser 60w, 600x400mm, not a k40.
But the thing im wondering about, is how do I figure out the best settings, in the shortest amount of time?
I know I can do trial and error, but there has to be a better and easier way, than to waste alot of materials?
Is there like a template, where you can set the various power/speed, cutting and engraving?
Any assistance will be helpful and much appreciated :)