Patrick Fleuret
09-23-2020, 7:32 PM
I'm putting up new siding and trim on our three buildings which is a lot of material. I got a new lightweight dual bevel saw and mobile stand so I can easily set up close to where I am working. The Milwaukee saw and the Ridgid stand work fine but repeat cuts are time consuming. I decided to adapt my Incra table saw sled. It was easy to do. The Incra fence with stop is mounted to a wood table which is mounted to a set of Ridgid saw mounts. With the fence I can do repeat cuts up to 70". The Incra stop has a 5" rod which I replaced with a 12" rod to get closer to the miter saw blade. This makes good use of the Incra fence which otherwise spends 99% of its time under the table saw. The table provides a handy place for pencils, tapes, etc.