Roborest on 6" grinder

[Kevin Jenness]

I set up a Roborest just now on my 6" bench grinder. It is a slick rig. The marked angle settings are off considerably but I don't see that it matters much. I will find the settings for my commonly used angles and use those, perhaps marking the hole position on the tools.

I am constantly switching between gouge cuts, shear scraping and negative rake scraping and sharpen often so this will make setting the sharpening angles far easier. Thanks, Reed.

[Pat Scott]

I have a RoboRest too. I wrote the angle settings on each of my tools, it sure makes things quick and easy and repeatable.