Mark Gibney
08-28-2020, 11:59 AM
I need a sleeve for a housing that takes a 62mm OD bearing.
The housing is damaged, and will need to be machined to round (I got this machine used, so I don't know what happened).
The next size bearing available is 68mm OD, too big, there is not enough meat on the housing to machine 3mm away.
The depth of the housing is about 23mm, but my machinist can trim a sleeve to length if it is longer.
Thanks!
Mark
The housing is damaged, and will need to be machined to round (I got this machine used, so I don't know what happened).
The next size bearing available is 68mm OD, too big, there is not enough meat on the housing to machine 3mm away.
The depth of the housing is about 23mm, but my machinist can trim a sleeve to length if it is longer.
Thanks!
Mark