Adam Brownstein
08-24-2020, 11:14 PM
439658
Posted a picture but I'm not sure if people will be able to see it.
I am making a rolling outfeed table with drawers for all my small parts (nuts, bolts, screws, switches, etc. I have been 3ds printing 100's of small boxes to hold all the misc stuff.
I am using full extension slides (thus the 1/2" gap on either side of the drawers"). The drawers are set back 3/4" and the false fronts (which have been removed in the picture) will be attached to make the front of drawers flush with the cabinet. I plan to leave about an 1/8" gap all the way around when I put on the false fronts.
My question is, "If I only have a 1/4" gap between the drawers (not the false fronts but the actual drawers), will it cause headaches when installing the drawers." It does not leave me with a whole lot of wiggle room for error. I am trying to maximize space and since all the parts in the drawers are small parts, I don't have to work about drawers jamming others drawers when opening/closing. Thanks!
(Had to type this all twice, since my cat decided to hit the backspace key!!!)
Thanks!
Posted a picture but I'm not sure if people will be able to see it.
I am making a rolling outfeed table with drawers for all my small parts (nuts, bolts, screws, switches, etc. I have been 3ds printing 100's of small boxes to hold all the misc stuff.
I am using full extension slides (thus the 1/2" gap on either side of the drawers"). The drawers are set back 3/4" and the false fronts (which have been removed in the picture) will be attached to make the front of drawers flush with the cabinet. I plan to leave about an 1/8" gap all the way around when I put on the false fronts.
My question is, "If I only have a 1/4" gap between the drawers (not the false fronts but the actual drawers), will it cause headaches when installing the drawers." It does not leave me with a whole lot of wiggle room for error. I am trying to maximize space and since all the parts in the drawers are small parts, I don't have to work about drawers jamming others drawers when opening/closing. Thanks!
(Had to type this all twice, since my cat decided to hit the backspace key!!!)
Thanks!