Craig Meaney
08-22-2020, 6:32 PM
Hi everyone- I split end grain on nearly every board nailing the backboards to my Dutch tool chest today, despite predrilled/tapered holes. Should I (try to) pull these off and make new T+G, or do you think I’ll be OK structurally speaking with these splits in place? Perhaps a little thin super glue could be a remedy? Pics attached.
I suppose I should’ve stopped and changed my drill bit. This didn’t happen on my test boards. I read Chris Schwarz blog about clamping the end grain after the fact.. lesson learned.
thank you for the advice.
craig439562439563439564439565439566
I suppose I should’ve stopped and changed my drill bit. This didn’t happen on my test boards. I read Chris Schwarz blog about clamping the end grain after the fact.. lesson learned.
thank you for the advice.
craig439562439563439564439565439566