Ed Lang
12-30-2005, 11:28 AM
I would like to cut out one of Keith's acrylic box today. I only have 1/8" material. I will need to resize the tabs for the box joints so they do not stick out too far.
I bet there is a better way than to move each point one by one by hand and use a grid line to match them up.
Since I am new to Corel, all suggestions are welcomed!
I bet there is a better way than to move each point one by one by hand and use a grid line to match them up.
Since I am new to Corel, all suggestions are welcomed!