PDA

View Full Version : RDCam V.8 Change Laser ID's?



George M. Perzel
08-01-2020, 9:24 AM
Hi Guys;
I am running RDCam v.8 on a twin head 130 watt/head Quantam laser (new) and, after much confusion, found that the RDCam software
has switched the ID's of the heads. machine Laser 1 is software Laser 2 and vice versa. No problem when settings are the same for both lasers but a mess when tweaking settings if you are unaware of the switch. Anyone know how to change the software designations?
Thanks

Jerome Stanek
08-01-2020, 7:45 PM
Can you change it in the vendor settings

George M. Perzel
08-02-2020, 7:24 AM
Jerome;
I looked at that and can't find anywhere to switch them. Not sure how RDCam decides which is which.
Thanks
Best regards;
GM Perzel

George M. Perzel
08-18-2020, 7:08 PM
Exchange CN5 and CN6 plugs on controller board- all OPK
Best regards;
GM Perzel
Laserarts