For those who have upgraded the Hammer K3 cross cut fence stop ...

[Derek Cohen]

If you have upgraded the fence stop, this is what you now have ...

https://i.postimg.cc/TPCJXp1F/Mitre-stop1-1.jpg

I made the swap about a year ago, and wondered what I could do with the old stop. Then it dawned on me that it could be used as a stop - not for the cross cut, but for the mitre.

Set up the mitre accurately ...

https://i.postimg.cc/LsH37z9j/Mitre-stop1.jpg

https://i.postimg.cc/hjvb4c7j/Mitre-stop2.jpg

Now install the stop behind the fence ...

https://i.postimg.cc/rst1Wjj2/Mitre-stop3.jpg

https://i.postimg.cc/ZRQPC2rL/Mitre-stop4.jpg

When not in use, it drops away ...

https://i.postimg.cc/XXSwg51G/Mitre-stop5.jpg

Regards from Perth

Derek

[Rod Sheridan]

Looks good except I normally move the extension table.....Rod

[Jim Becker]

Seems like a nice way to lock in "dead accurate" a particularly common angle you might use with your work for sure.

[Steve Wurster]

Nice idea, Derek. I might have to do that next time I need to make some miter cuts.