Mike Henderson
07-05-2020, 9:16 PM
My wife inherited four hand saws from her father. She asked me to clean them up which I did. I took the handles off and soaked the saw plates in EvapoRust. Then I refinished the handles. I'll get them sharpened - I don't have the equipment or experience to sharpen hand saws.
The two shorter saws were in the worse shape, with more rust and the handles were not in great shape (but with some glue and sanding, they cleaned up well.)
Anyway, here they are.
The first on is a 26 inch Disston D-23, 10ppi Crosscut.
436229
The second is a 25 3/4 inch Disston Keystone K-4, 8ppi Rip. It has a logo of a B-29 (I think) and the words "Air Master". So this one is certainly after WWII. I learned that the Keystone was a value line saw.
436228
The next is a 19 3/4 inch Zenith, 12ppi, Crosscut
436231
The last is an 18 inch Disston, 8ppi Rip, probably a D-8.
436230
Any comments you might have about them will be appreciated - Quality saws? What should I do with them? Value? Etc.?
Mike
The two shorter saws were in the worse shape, with more rust and the handles were not in great shape (but with some glue and sanding, they cleaned up well.)
Anyway, here they are.
The first on is a 26 inch Disston D-23, 10ppi Crosscut.
436229
The second is a 25 3/4 inch Disston Keystone K-4, 8ppi Rip. It has a logo of a B-29 (I think) and the words "Air Master". So this one is certainly after WWII. I learned that the Keystone was a value line saw.
436228
The next is a 19 3/4 inch Zenith, 12ppi, Crosscut
436231
The last is an 18 inch Disston, 8ppi Rip, probably a D-8.
436230
Any comments you might have about them will be appreciated - Quality saws? What should I do with them? Value? Etc.?
Mike