PDA

View Full Version : Refinish this door



Jack Frederick
06-16-2020, 3:07 PM
I built these doors when I built the shop in ‘15. They are redwood out of some very old 3” wine tanks. Trim is purple heart. The 3/8” panel shown is the problem. The cathedrals are beginning to feather off. The finish was a few coats of Daley’s Shark fin Oil and a few coats of Arm-r-seal poly. The doors are under a 12’ deep porch but the late pm summer sun blasts them. I hope to not have to finish the entire door and am afraid that without some care the panel will split. What do you think would be best?435161

Mel Fulks
06-16-2020, 3:24 PM
The peeling probably means those pieces have the wrong side out. The "bark side" should on the exterior side. If they
have no cover I would add a "drip moulding , perhaps one at top and bottom.