dado plane

[Mark Rainey]

Making a chest of drawers and enjoying cutting dados with HNT Gordon 3/4 inch dado plane. Wow, I was able to crank out these dados in 30 minutes. I had to do each side separately because the sides were slightly different in thickness.

434448434449434450

[David Eisenhauer]

It's nice when a tool does just exactly what it was supposed to do after being sharpened and set up as intended. I have never had the opportunity to try out an HNT G tool, but have always suspected they performed at the top of the line.

[Josh Robinson]

Sweet! Nice job.

[Jim Koepke]

Having the right tool for the job can speed things up.

Are you going to add trim to the front or will they have the through dado look?

jtk

[Mark Rainey]

Having the right tool for the job can speed things up.

Are you going to add trim to the front or will they have the through dado look?

jtk Jim, I am going to add some veneer to cover the through dado look. It was so much quicker to run it all the way from end to end. A stopped dado would be more work ( as you have illustrated some work arounds in some past postings )

[Christopher Charles]

Oooh, looks like a good project. And I'm trying to look way-the plane looks excellent. Will look forward to seeing more.

Best,
Chris