Maurice Arney
05-12-2020, 4:44 PM
Hello! This is my first attempt at making bread board ends and I have a question. So I glued up a a 33" x 65" table top from six lengths of 5/4"x6" cherry stock. I also have 3 1/2" breadboard ends mortised and dry fit on 2 inch deep tenons which run the width of each end. Is it okay to drive my center dowel pin through the glue seam of the two middle boards? Where should I apply glue? Or should I just treat the piece as one large panel and not worry about the glue seams?
Thanks!
Thanks!