Bill Dufour
05-08-2020, 4:56 PM
On a unifence is there any way to make my own fence rail like you can on other biesmeyer type ones?
Bill D
Jim Becker
05-08-2020, 5:50 PM
Bill, if I recall, the extrusion that the UniFence uses isn't a "simple" hollow rectangle like the typical "tee square" type fence uses so I suspect rolling your own will be difficult. If you need a longer one, you may best be served by keeping your eye out for someone selling a UniFence. Just be sure it's the same generation...if I'm not mistaken, there were two slightly different versions over time, but I could be wrong about that.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.