Bryce Walter
05-04-2020, 9:21 PM
I have a 1221vs lathe. The other night it was acting wonky with regards to the rpms. When I had it in high gear, the RPM range reflected it being in Mid gear. When in mid gear, it acted like it was in low gear. This behavior was intermittent.
The manual says to check electrical voltage if the rpm displayed is too low. Checking tonight, it shows fine but I'm also not able to get the lathe to repeat its bad behavior. We've also never had electrical issues in the house.
The lathe is less than 6 months old with very light usage.
Anything else that could cause the wrong rpm range or display?
The manual says to check electrical voltage if the rpm displayed is too low. Checking tonight, it shows fine but I'm also not able to get the lathe to repeat its bad behavior. We've also never had electrical issues in the house.
The lathe is less than 6 months old with very light usage.
Anything else that could cause the wrong rpm range or display?