Eric John
05-04-2020, 10:45 AM
Good day everybody
current project is an oval coffee top. i have veneered a sunburst pattern on the top, which I
think came out ok for first try. would have been nice to have a vacuum press but
mdf panels and cauls got me through the glue up.
I'm wanting to put a crossbanding border about 1" wide around the perimeter.
so i can use the ellipse jig to follow the oval but wondering how to cut the veneer
pieces to fit around the curve.
how have others done it?? i get the feeling its going to be a piece at a time process.
any ideas appreciated
Regards,
Eric
current project is an oval coffee top. i have veneered a sunburst pattern on the top, which I
think came out ok for first try. would have been nice to have a vacuum press but
mdf panels and cauls got me through the glue up.
I'm wanting to put a crossbanding border about 1" wide around the perimeter.
so i can use the ellipse jig to follow the oval but wondering how to cut the veneer
pieces to fit around the curve.
how have others done it?? i get the feeling its going to be a piece at a time process.
any ideas appreciated
Regards,
Eric