Delta Table Saw 34-426 vs 34-338

[Graham Bowen-Davies]

Anyone know, or can point to a resource that would let me know if these saws have the same inner workings? Is there any logic to their numbering convention that I an intuit on? Comparing the schematics, they look to be the same. I have the 426, but I've found parts that I need (or just want actually) for the 338, which motivates the question.

Thanks in advance

[Mike Kees]

Graham if you are talking about the Delta Contractor saws there were very few changes to that design over time. The older Rockwell ones had a slightly different arbor but other than that they are pretty much all the same. I have owned a lot of Delta and Rockwell stuff and still have affinity for their stuff.I have never figured out why they changed model numbers and part numbers so much.

[Graham Bowen-Davies]

Thanks,

I found the relevant parts lists, and the parts numbers were the same - so I went ahead and got the bits off ebay.