Mike Henderson
03-19-2020, 11:03 PM
I have a MicroFence setup and have the adapter for the Dewalt 611 plunge base (see pictures). However, I'm having problems figuring out the screw size to use to hold the adapter in the plunge base.
The screw socket next to the slots for the edge guide rods (on the right side of the pictures) takes a metric 6-1mm so I assume the threads for the edge guide are metric. The screw socket for the edge guide is smaller than the 6-1mm so I tried 5-.8mm but it won't screw down. The size (diameter) fits but it feels like the threads are not a match. I don't want to force the screws unless I know what the threads are. If they're 5-.8mm I can just force screws of that size down.
Has anyone used those screw sockets? And if so, what size and threads are they?
Mike
428408428409
The screw socket next to the slots for the edge guide rods (on the right side of the pictures) takes a metric 6-1mm so I assume the threads for the edge guide are metric. The screw socket for the edge guide is smaller than the 6-1mm so I tried 5-.8mm but it won't screw down. The size (diameter) fits but it feels like the threads are not a match. I don't want to force the screws unless I know what the threads are. If they're 5-.8mm I can just force screws of that size down.
Has anyone used those screw sockets? And if so, what size and threads are they?
Mike
428408428409