Casolin f90 shaper (control panel?)

[Jared Sankovich]

Even though I have the manual for this machine this specificstart/reverse switch setup is absent from it. There is a section referening double speed though. The Y and delta symbols make me wonder. Any thoughts?
428065

428063

[David Kumm]

The speeds don't look like a two speed motor set up. They would be doubles, 3000,4500,6000,9000, or something similar. The starters could be Wye Delta which just lowers the start up amps. You start out on wye and after the motor speeds up you turn to delta for full HP. Dave

[Darcy Warner]

Top left is electric brake, middle is main power disconnect, top right is Wye Start Delta run in either forward or reverse.

[Jared Sankovich]

Thanks David and Darcy.

[Steve Jenkins]

If you’re not used to European machines bottom left is stop that locks in when pressed. Turn it slightly clockwise and it will pop back out to allow it to run.

[Jared Sankovich]

If you’re not used to European machines bottom left is stop that locks in when pressed. Turn it slightly clockwise and it will pop back out to allow it to run.

I realize my original post was less than clear. It was just the wye/delta start switch that was new to me.

Though regarding the e stop I personally hate them when used as the only stop button (obviously not the setup this machine)