steven c newman
03-07-2020, 7:52 PM
Noticed one of the egg beaters hanging up in the shop...was getting a few rust spots.....basement shop, go figure.
Wire wheel to clean things up. A drop of 3in1 oil where needed....add a drill bit, and test drive....nice and quiet, and fast..
427550
Yeah, yeah..just a single speed, single pinion drill...
427551
Didn't find much in the way of Maker's Marks...
427552
Only thing on the gear crank, was a "Made in USA"....the chuck?
427553
No markings...3 jaws....might be a 1/4" chuck?
It was at the end of the top handle, were things got...special.....:cool:
427554
You move that tab around to the left...and a access hole opens up, for bit storage...I guess that is better than those wooden caps most drills use?
Now, I just have to find out who made this drill....:confused:
Wire wheel to clean things up. A drop of 3in1 oil where needed....add a drill bit, and test drive....nice and quiet, and fast..
427550
Yeah, yeah..just a single speed, single pinion drill...
427551
Didn't find much in the way of Maker's Marks...
427552
Only thing on the gear crank, was a "Made in USA"....the chuck?
427553
No markings...3 jaws....might be a 1/4" chuck?
It was at the end of the top handle, were things got...special.....:cool:
427554
You move that tab around to the left...and a access hole opens up, for bit storage...I guess that is better than those wooden caps most drills use?
Now, I just have to find out who made this drill....:confused: