Tim M Tuttle
02-25-2020, 2:26 PM
I have the 12" Bosch Glide miter saw. Most of the time I just use it for rough breakdown but I had some longer parts I needed to cut square so I wanted to make sure it was dialed in. My first cut of about a 10" wide piece was about .2 degrees out of square so I loosened everything up, got it square, and then checked by making some cuts. .2 degrees out of square again. Loosen, check, recut, .2 out of square. Rinse, repeat about five times. At this point I was obviously really frustrated. As I was doing more fiddling I realized what was going on; when I tighten down the miter lock knob, it skews to one side just a bit.
Anyone had this problem? Any suggestions on finding/fixing the culprit?
Anyone had this problem? Any suggestions on finding/fixing the culprit?