Steven Todorow
02-17-2020, 5:46 AM
So i recently bought a table saw my first one as my first post here.
But I am having some issues with the blade guard or I think they are issues. So I put the guard on, put a piece of stock next to the blade raise it up to about a teeth above and the run a false pass through the saw and it hits a bolt in the back. And I know there debate whether or not the blade is supposed to be high or low when cutting.
so I raise the blade up and the board passes through just fine itÂ’s not all the way up but about 75% up. So is this normal or did I install something wrong? Just a little confused when people say the blade is supposed to be just above the wood but my blade guard interferes with that.
Any insights would help. Just wanna know if itÂ’s gonna cause an issue or not. Thank you
But I am having some issues with the blade guard or I think they are issues. So I put the guard on, put a piece of stock next to the blade raise it up to about a teeth above and the run a false pass through the saw and it hits a bolt in the back. And I know there debate whether or not the blade is supposed to be high or low when cutting.
so I raise the blade up and the board passes through just fine itÂ’s not all the way up but about 75% up. So is this normal or did I install something wrong? Just a little confused when people say the blade is supposed to be just above the wood but my blade guard interferes with that.
Any insights would help. Just wanna know if itÂ’s gonna cause an issue or not. Thank you