View Full Version : need replacement pin for Robo Rest.
Lance Mirrer
02-10-2020, 5:17 PM
Hi,
Anyone have an extra Robo Rest Pin, or know a good replacement?
Thanks!!
Sent e-mail to company, waiting for response.
Chris A Lawrence
02-10-2020, 6:38 PM
The owner of the company is active here. His name is Reed Gray aka robo hippy
Bob Coates
02-10-2020, 6:47 PM
Didn't check but long allen wrench may work
Dwight Rutherford
02-10-2020, 7:59 PM
The “pin” on my Robo Rest is 1/8” diameter. A hobby shop should have what you need. Perhaps Reed Gray will chime in.
Peter Blair
02-11-2020, 9:21 AM
I'd just find a piece of 1/8" round stock put a little bend in it and walla!
Reed Gray
02-11-2020, 12:46 PM
It is a loop T handle 6 inch hex wrench. You can probably find one at any big box hardware store or Graingers, or Fastenall. and probably cheaper than I could send you one for...
robo hippy
Dave Fritz
02-12-2020, 9:58 AM
Has to be a story about why you need one. 😄
Reed Gray
02-12-2020, 11:08 AM
Ummm, it has to be the shavings.....
robo hippy
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.