camheads

[Johannes Becker]

I am looking at cnc machines and camaster has caught my attention. Not sure whether I am ready to spend that kind of money or try something cheaper first, but I like the idea of not spending the little shop time I have on getting a CNC to run.

To get a better idea I wanted to register on the forum but have been waiting for activation for more than 3 months now. Unfortunately that means I cant see any pictures. I tried contacting the admins there but did not get any response. Is anybody here a member on the camheads forum as well and can provide some advice?

Thanks,
Johannes

[Mark Bolton]

I had a similar experience a long while back (not a camaster owner) but it eventually got sorted. Im not sure it took 3 months though. Hard part is a lot of the owner forums are privately run so they can be a bit slow in that people are earning a living in addition to the forum. James, and several other camaster owners, are here so I would guess you'd get some response. James is also relatively active (just in the past few days) over on Wood web so you may look there as well. You can direct message him there.

[bobby milam]

I have access to the forum. I will let then know.

[bobby milam]

I just sent a PM to Jim and hopefully he will come over here and get you fixed up. I'd you don't heat back let me know and I'll contact someone else

[Johannes Becker]

thanks bobby, the help is much appreciated! I know that the moderators are often doing the work in their spare time so I was prepared for it to take a while.

Johannes

[Bruce Page]

If the above doesn’t work you can contact Jim McGrew (admin) at http://www.mcgrewwoodwork.com

Ps., I love my solid as a rock Camaster

[David Buchhauser]

I believe that Jim Becker is one of the camheads moderators. Perhaps he can help.
David

[Bruce Page]

I believe that Jim Becker is one of the camheads moderators. Perhaps he can help.
David

Jim is a Camheads member but is not a moderator there.

[Jim Becker]

Jim is a Camheads member but is not a moderator there.

Correct, but I've often done as Bobby mentions and ping Jim McGrew when something gets missed in the queue. The community forum isn't run by the manufacturer.

Johannes, if I can help you with any questions, please let me know, too.

[bobby milam]

Did anyone get hold of you?

[Johannes Becker]

Not yet. I resend an email as well figuring it would get me on top of their inbox again.

Thanks, Johannes

[bobby milam]

I got hold of Jim and let him know. I gave him a link to this thread so maybe he will come over and get you set up.

[james mcgrew]

I have searched for Johannes registration and cannot find it with the name only

I cannot change status unless registered and need your correct screen name

em me at mcgrew 636 at g mail dot com

[james mcgrew]

Not yet. I resend an email as well figuring it would get me on top of their inbox again.

Thanks, Johannes


If you contact me I can do this,, I get every post every new member email and every support email..

most do reply to the verification email and get access. it does happen to some when they miss this. so again I can help.. just send me the screen name you joined with.

[james mcgrew]

I have tried to reply here. I do not see the post i made..

feel free to contact me for access to camheads

I just need a registered screen name. I do not see your Name as a screen name in the Que for access

[Johannes Becker]

Thanks Jim. The screen name is j-becker. I tried emailing you yesterday with it at your email above.

Here is the message I get when I try to open pictures. I thought this is due to activation.

Best,
Johannes



424841

[james mcgrew]

That is all I needed ,, you are in ! feel free to post and see photos !

[Johannes Becker]

Yay, it worked! thanks a lot Jim!

Johannes