PDA

View Full Version : Foley Belsaw Planer



Tom Megow
01-16-2020, 6:35 PM
my old FB 12” planer tried to start yesterday spun slowly then quit. I let it cool down but it has never tried to start again. Thinking starting capacitor. Pulled off the rear cover and it has what looks like 3 capacitor. Two black ones together and an Aluminum colored one by it self. I was thinking just replace all three. I live in rural Alabama next township past nowhere. Getting a service tech out here it impossible.
Loading this monster in my truck is possible if i use my front end loader.
Any one know who could service this planer in the Oxford/ Anniston area of Alabama
or got any advise?
Thanks
Tom Megow
Delta, Al

John TenEyck
01-16-2020, 7:50 PM
Unless you suspect the starter to be the problem, just remove the motor and take it to a motor shop. They'll fix whatever's wrong with it.

John

Eugene Dixon
01-16-2020, 7:59 PM
Spent formative years in Munford on a dairy farm. Church in Estaboga. Mother was from Clay county, Shinbone Valley, next to Catchmedoggie (sp) creek.

Thrity/forty years ago, I might have known somebody. Look for capacitors that are out of round or swollen ends or leaking. You should find marking on them. You can order capacitors on line. You might be out $30 for changing the capacitors and finding out that the windings or centrifugal switch needs attention. Rewinding can be expensive. The switch can be expensive (from an electrical house) but you can find replacement parts often at some reasonable prices.

Lee Schierer
01-16-2020, 8:48 PM
I would check that the centrifugal switch in the end of the motor is working properly. Sawdust can accumulate and interfere with the proper operation of the switch. There may be nothing wrong with you capacitors. The cure may be as simple as blowing out the sawdust once you remove the cover. Witht he power disconnected, see if the motor shaft and pulleys rotate freely.

Eric Danstrom
01-18-2020, 1:51 PM
If I was in your position I'd pull the motor and drive 25miles east to Electric Motor Repair Of Anniston Ala Inc.

Tom Megow
01-20-2020, 2:05 PM
i did carry the planer into Anniston. Motor is shot

Thanks