Simple question here ...

[Tim Boger]

I want to make some coasters using 1/8th cork and 1/2in hardwood.

Does the cork go face up or down? If the cork is up, what is a good sealer if any?

I want to do some Laser Engraving on which ever material is visible.

Thanks for the suggestions,
Tim

[Mike Henderson]

I would make them with the cork down to protect the surface they're put on. After all, that's why we use coasters.

I'd make them round and turn the wood so that there's a slight raised ring around the outside. Finish with something that can resist water from condensation. Or put cork in the center of the wood, inside the raised ring.

Mike

[Tim Boger]

I would make them with the cork down to protect the surface they're put on. After all, that's why we use coasters.

I'd make them round and turn the wood so that there's a slight raised ring around the outside. Finish with something that can resist water from condensation. Or put cork in the center of the wood, inside the raised ring.

Mike

Thank you Mike for your thoughts.
Tim

[Rich Engelhardt]

Either or as far as up or down...

I'd leave the cork unfinished since it's job is to soak up condensation & protect a surface from moisture. If sealed, the moisture would just puddle and eventually spill - defeating the purpose of the cork.

[roger wiegand]

cork down to keep the surface you're trying to protect from getting scratched. Cork on the other side as well if you like that look/feel. Dish the top to keep condensation/spills from running off the coaster and onto the surface you're trying to protect.

[Tim Boger]

Either or as far as up or down...

I'd leave the cork unfinished since it's job is to soak up condensation & protect a surface from moisture. If sealed, the moisture would just puddle and eventually spill - defeating the purpose of the cork.


Good point Rich, thank you.

[Tim Boger]

Hey Roger, If the cork is down and I choose a wood surface facing up do you apply a finish to the wood? Recommendations? Thank you.

cork down to keep the surface you're trying to protect from getting scratched. Cork on the other side as well if you like that look/feel. Dish the top to keep condensation/spills from running off the coaster and onto the surface you're trying to protect.

[Lee Schierer]

We have a variety of coasters with cork. The ceramic ones have the cork on the bottom. The wooden ones have the cork in the glass recess on the top.

[roger wiegand]

Hey Roger, If the cork is down and I choose a wood surface facing up do you apply a finish to the wood? Recommendations? Thank you.

I'd use polyurethane for water/alcohol resistance.