Ron Citerone
11-27-2019, 8:50 AM
Hey Gang,
My mechanic who is also a good friend put an old maple top on his new work bench. It has 12 holes in it from vises that were mounted through the years. He asked me to fill them as a favor. The top is about 1 1/2" thick.
If I were to rout/chisel a plug to fill the holes, how deep should I go? Is 1/2" enough?
Other ideas of other methods are welcome also..................I don't want to fill the holes with epoxy though.
Thanks, ron
P.S. the holes are 5/8" dia with crushed wood from the washers about an 1"
Ron
My mechanic who is also a good friend put an old maple top on his new work bench. It has 12 holes in it from vises that were mounted through the years. He asked me to fill them as a favor. The top is about 1 1/2" thick.
If I were to rout/chisel a plug to fill the holes, how deep should I go? Is 1/2" enough?
Other ideas of other methods are welcome also..................I don't want to fill the holes with epoxy though.
Thanks, ron
P.S. the holes are 5/8" dia with crushed wood from the washers about an 1"
Ron