Festool CT 22 hose to Kreg K4 Pocket Hole Jig

[Vince Shriver]

What fitting is required to connect the Festool hose to the Kreg K4 Jig dust port? Thank you, Vince

[johnny means]

I use something like this https://www.woodcraft.com/products/dust-port-adapter-triton?gclid=Cj0KCQiAtrnuBRDXARIsABiN-7DzVh_R6jbw0AYn0CmC3tSlsBgMZn9J8QXwFNAXNPGXKcFyWTB BmhkaAi-vEALw_wcB. I keep a few of these around so I can cut them up as needed.

[fred woltersdorf]

I found a piece of thin wall pipe in the plumbing section of HD that the festool hose would fit onto but was a hair small for the Kreg jig, I heated that end of the pipe with a heat gun and slide over the Kreg port and it did the trick, I believe the pipe was in the sink repair section for a $1 or $2.