Bringing G0634 Jointer Tables Parallel

[Jeff Milos]

My jointer/planner combination unit’s tables came WAY out of parallel. The odd thing is happened overnight, with no good reason why, The Infeed table is sloped down going left to right, and forward front to back. The two are significantly off. I played with it for a while and called Grizzly, but am still stuck. I attempted to tighten/loosen the appropriate screws with no success.

Anyone have any thoughts for how to correct this?

[Steve Jenkins]

Where are you located. May be someone close that can give you a hand. I know I enjoy helping out.