T&G V Groove on both sides of Board

[Ray Boaz]

I am making a garden gate that will have 3/4" T&G V groove board infil. I am looking for router bits set to cut the V Groove on both sides of board but cant find anything but ones that cut the V Groove on one side. Can anyone direct me to source for this type bit. Or do i have to flip each board over and run thru router with V Bit.

[Paul F Franklin]

Maybe one of the bits for plywood edge banding would work (with a shallow cut of course). This amana says it has 1" cutting height so it should work with 3/4 stock.

https://www.toolstoday.com/v-9854-55468.html?glCountry=US&glCurrency=USD&ne_ppc_id=1701009076&gclid=EAIaIQobChMIooqZnfCz5QIVB_5kCh1lrgGjEAQYASAB EgJkHvD_BwE

Kinda pricy though...

[Gary Ragatz]

MLCS has them at a lower price point - https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_edgeband_ogee.html

I have no experience with these, but they were mentioned in a recent Wood Magazine piece on finishing edges on sheet goods.

[johnny means]

Just run both faces. I can't imagine that such a bit would have enough buyers to warrant manufacturing.

[David Buchhauser]

But Johnny,
Here it is. There is apparently a market for these cutters, or they probably wouldn't make them. I didn't even know that these were available.
David

https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_edgeband_ogee.html

418198 (https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_edgeband_ogee.html)

[johnny means]

But Johnny,
Here it is. There is apparently a market for these cutters, or they probably wouldn't make them. I didn't even know that these were available.
David

https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_edgeband_ogee.html

418198 (https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_edgeband_ogee.html)
Im pretty sure the OP was asking about a tongue and groove with a chamfer that leaves a v-groove between adjacent boards. Basically, this with two faces.

[Adam Herman]

are most of them with the tongue not centered in the stock? i have not found one that has it centered yet, that you could just flip the board and run it through the same set up.