Steve H Graham
10-23-2019, 1:55 PM
I have a Shark Guard for my Powermatic 66. No complaints. Unfortunately, when I moved, I lost the smallest splitter that came with the guard. Figured I would make a new splitter. I'm talking about a very low splitter for things like plywood.
I notice the other Shark Guard splitters are .105" thick, for a 1/8" blade. Is there a recommended width for splitters? I have steel roughly this thick. I can sand a few thousandths off if needed.
I'm thinking I'll make my splitter about 1/2" high.
I notice the other Shark Guard splitters are .105" thick, for a 1/8" blade. Is there a recommended width for splitters? I have steel roughly this thick. I can sand a few thousandths off if needed.
I'm thinking I'll make my splitter about 1/2" high.