orren countin
09-30-2019, 11:44 AM
I got my first router lift, a used Bench Dog with cast iron plate and Porter Cable 7518 3 1/4 hp router. It does not seem to work well with large bits. In this instance a 1/2" following trim bit 3" long and 3/4 diameter. The bit is slightly off kilter and you can see a slight wobble. 2 identical bits same problem
Ive used this bit in another table router with a Hitachi M12v 3 1/4hp router with not lift and had no problems.
Is there an inherent issue with router lifts using larger bits and holding center?
Ive used this bit in another table router with a Hitachi M12v 3 1/4hp router with not lift and had no problems.
Is there an inherent issue with router lifts using larger bits and holding center?