David Sabot
09-27-2019, 4:53 PM
We have a GCC Spirit 45w laser that is giving us some problems.
This is the image I am trying to engrave. It is just a solid black rectangle
416946
This is the output
416948
You can see it starts to engrave then peters out.
I suspect a laser power issue, such as the tube going. If I turn the machine off for a while and start it up, I can get it to engrave again, then it peters out.
Any ideas?
This is the image I am trying to engrave. It is just a solid black rectangle
416946
This is the output
416948
You can see it starts to engrave then peters out.
I suspect a laser power issue, such as the tube going. If I turn the machine off for a while and start it up, I can get it to engrave again, then it peters out.
Any ideas?