mreza Salav
09-13-2019, 12:06 AM
For a couple of houses we are doing some higher end cabinets and for all kitchen drawers (which will be Blum Legrabox) we will be adding Servo-drive electric opening for all drawers/pull outs. I've sourced out a big shop with all CNC equipment to build all the boxes and fronts and they do most of the hardware installation as well. I will be installing some of the hardware (including these servo-drive systems) myself. Haven't done this before but have looked up the process, so doesn't seem complex.
One issue I have is that for a base cabinet (36" wide) which will have a gas cook-top at the top then a 6" false front and then two 12" drawers at the bottom, the gas pipe is coming up from the floor at the far back of the cabinet is likely to interfere with the vertical support rail/profile for the servo-drive.
Those that have installed this, will it be Ok if the servo drive is not completely center of the drawer? or should I try to move the gas pipe in the back to make the arms hit the back of the drawer center? I know the brackets for the support have top/bottom but can it be installed upside down with the arm being on the left side of the servo-drive instead of the other way around? This would mean the actual vertical profile will be to the right of the center instead of left of center if it would interfere with the location of gas pipe.
Any advice from those experienced is appreciated.
One issue I have is that for a base cabinet (36" wide) which will have a gas cook-top at the top then a 6" false front and then two 12" drawers at the bottom, the gas pipe is coming up from the floor at the far back of the cabinet is likely to interfere with the vertical support rail/profile for the servo-drive.
Those that have installed this, will it be Ok if the servo drive is not completely center of the drawer? or should I try to move the gas pipe in the back to make the arms hit the back of the drawer center? I know the brackets for the support have top/bottom but can it be installed upside down with the arm being on the left side of the servo-drive instead of the other way around? This would mean the actual vertical profile will be to the right of the center instead of left of center if it would interfere with the location of gas pipe.
Any advice from those experienced is appreciated.