ChrisA Edwards
08-30-2019, 1:26 PM
So I was using my Bosch Palm router, for the first time, with a 1/4" spiral up cut bit.
I needed to cut a square hole out of a 3/4" piece of plywood. I figured I'd make two or three passes, adjusting the depth on each pass.
I could not get the base to clamp tight enough to stop the bit basically pulling the motor down inside the exterior base. I adjusted the 8mm lock nut that is on the clamping mechanism, as tight as I could get it, but still be able to use the toggle eccentric clamp.
Any one else had a similar issue. or have suggested solution?
https://images-na.ssl-images-amazon.com/images/I/817SCqtzmpL._SL1500_.jpg
I needed to cut a square hole out of a 3/4" piece of plywood. I figured I'd make two or three passes, adjusting the depth on each pass.
I could not get the base to clamp tight enough to stop the bit basically pulling the motor down inside the exterior base. I adjusted the 8mm lock nut that is on the clamping mechanism, as tight as I could get it, but still be able to use the toggle eccentric clamp.
Any one else had a similar issue. or have suggested solution?
https://images-na.ssl-images-amazon.com/images/I/817SCqtzmpL._SL1500_.jpg