David Sabot
08-22-2019, 10:59 AM
I am using Smartcarve and it outputs an .oud file for cutting.
We produced a perfect rectangle in Smartcarve, but when cut the end result is not perfectly square. It is off by quite a bit.
I was wondering if anybody here had Smartcarve and could try our file to see if it produces the same wonky result, or if it is just our machine?
We produced a perfect rectangle in Smartcarve, but when cut the end result is not perfectly square. It is off by quite a bit.
I was wondering if anybody here had Smartcarve and could try our file to see if it produces the same wonky result, or if it is just our machine?