Joe Hollis
07-13-2019, 6:24 PM
Hello,
I did about 15 minutes in total of sanding, using a 3" diameter drum sander mounted on my drill press.
After changing the two belts to drill a hole after the sanding was done, there appears to be a noise I have not heard before from my drill press (basic off-shore bench top model).
Is it possible that after brief use of a drum sander (never used it before) any damage could have been done to the drill press?
Thanks,
Joe
I did about 15 minutes in total of sanding, using a 3" diameter drum sander mounted on my drill press.
After changing the two belts to drill a hole after the sanding was done, there appears to be a noise I have not heard before from my drill press (basic off-shore bench top model).
Is it possible that after brief use of a drum sander (never used it before) any damage could have been done to the drill press?
Thanks,
Joe