How to shape radius table legs

[Jason Ferris]

Hi, I'm interested in building a table similar to the one in the attached photo. I'm wondering how to round the outer edge of the table legs into a soft radius as shown. You'll notice that the inside edges are square. I was thinking several passes on a shaper with a large roundover bit? Thanks for the input!

[Mike Kees]

That is a one pass proposition on a shaper. You could either build a sled with hold down clamps and registration blocks to hold the leg precisely and feed by hand . Or if you have a power feeder set up and run it thru.

[Mike Kees]

If you use the sled option you will need a rub bearing sized to your cutter. Also when you make the sled it should be at least a foot longer than your legs so you can contact the rub bearing before the cutter engages the stock. If making the profile in one pass makes you nervous you could also remove some stock with a chamfer cut before running the profile on the shaper.

[Jamie Buxton]

I'm mostly a power tool guy, but that task can be done quickly and accurately with a hand plane. Mark the desired curves on the top and the bottom of the leg. Clamp the leg so that you can run the plane end to end without hitting the clamps; I'd use a bench dog and an end vise, but you may have some other scheme in your shop. Use the handplane to cut down to the lines at the top and bottom. You can do it in just a couple of minutes. When you're done with the plane, you'll have facets on the surface. They come right out with a sander. Using the handplace, you can even make a larger radius at the top than at the bottom, which is not something you can do with a roundover bit.

Whatever you do, mill the mortises in the leg top before you do the rounding over. While the leg is still square, you can easily hold it while you cut the mortises.

[Jason Ferris]

I really appreciate these replies, thanks!!

[Derek Cohen]

As with Jamie, I would saw the legs straight, then mark the round section, and plane it: rough out with either a jack plane, rasps, drawknife or spokeshave, and finish with scrapers and sandpaper. If you are familiar with hand tools, it is pretty straightforward.

Regards from Perth

Derek

[lowell holmes]

You can round edges with a router and a round over bit.

[Tom Bender]

Start with a 45 cut on the table saw then go to the hand planes.