Brian Lamb
06-30-2019, 12:33 PM
I'm working on a job for a customer and their logo is small and the parts are small. I think the smaller text is about 4 point. To the naked eye (well, with my glasses) it doesn't look too bad, but take a picture and enlarge it and I can see that I'm getting some ghosting or double images. I haven't gone thru yet and double checked that mirrors are tight, and it's possible that the back and forth movement is even jarring the part... it doesn't weigh much.
My question is, I guess, can you set the laser (Universal X-600) to only engrave in one direction, that way if there is slop in the mechanicals, coming at it from one direction only would sharpen things up. I did a quick look thru the software and didn't see any selections for single or two direction printing.
412094
My question is, I guess, can you set the laser (Universal X-600) to only engrave in one direction, that way if there is slop in the mechanicals, coming at it from one direction only would sharpen things up. I did a quick look thru the software and didn't see any selections for single or two direction printing.
412094